![]() ![]() Stick to the above treatment for all the colour combinations indicated in the check data table. Multi-meter should end up being set to: (a) Opposition range (b) 200 ohm level The following treatment should after that be implemented: 1.Ĭonnect one multi-meter prospect to the crimson cable and the additional lead to the natural wire and a reading through as indicated in the test data table should become present. Should the products referenced within this Common questions have been recently addressed and started problems continue, after that the fluxgate compass should become tested. Note: Because you align the compass after installation (see page 95),you can mount it so it faces in any direction.Should the proceeding temporary stop (i.at the. To achieve the best performance from the compass, mount it:Īs near as possible to the boat’s pitch and roll center to minimize compass disturbanceĪt least 0.8 m (2 ft 6 in) away from the boat’s steering compass to prevent deviation of either compassĪway from the front third of the boat (otherwise shock motion will affect compass performance)Īway from potential sources of magnetic interference, such as: motors, drive units, loudspeakers, alternators/starters, electric cables, large ferrous objects (such as the engine, ballast, keel, gas bottles and tool boxes) On steel-hulled boats you must mount it above deck. The compass is primarily designed for below deck, bulkhead mounting. It is caused by the pendulum weight hitting the inside of the case. ![]() Note: The rattle that the fluxgate compass makes when shaken is normal. ![]() This enables the compass to provide accurate readings with pitch and roll movements up to +/- 35°. The compass contains a self-levelling mechanism. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |